Already having ‘low power’, ‘high downtime’? B35 will be an even bigger challenge!
Want to know how to better manage your fuel doing your own particulate & water testing ‘on-site’ & ‘real-time’
Want to know how you can do your own FAME (biodiesel) % testing ‘on-site’ & ‘real-time’
Want to know how you can do continuous condition monitoring of your biodiesel that can live report locally or anywhere?
Would you like to see FluidTek’s complete procedures to optimally receive, store, condition & dispense biodiesel?
Since the introduction of biodiesel fuel blends, contamination has become a major issue, but much more so with slow moving fuels (standby gensets)!
What if you could get a portable testing unit, that could get you particulate (ISO) & water RH% ‘real-time’
What if you could also get some root cause analysis for particulate with the same small testing unit
What if you could get another portable testing unit to give you virtually every lab test parameter – ’on-site’ & ‘real-time’
FluidTek also can provide a complete no CAPEX service to give you all this analysis & digital reporting, including actively looking for ‘root cause’ for problems & developing countermeasures – at your site!
Modern condition monitoring sensors that can alert you continually for ‘in-situation’ & ‘real time’ on the health of your oils
Condition monitoring sensors that enable reducing operating costs, breakdowns & increase life & productivity
See any change in oil quality detected instantly, accurately measured & reported to you anywhere you need it
Track your oil life over its entire degradation cycle to understand if you could extend ODI’s & change it when it actually needs it
Oil condition is a critical indicator of early equipment problems. Being remotely monitored facilitates longer life with reduced maintenance costs
Modern condition monitoring sensors that can alert you continually for ‘in-situation’ & ‘real time’ on the health of your oils
Your biodiesel fuel in your standby genset tanks must be regularly treated for it to remain okay to use.
The fuel in your tanks will become so contaminated, your gensets will not run properly or may not start in an emergency when you need them
What if there was a way to safely clean both the tanks as well as the fuel for reliable use, while it is still in the tank & ready if you need it (online)
FluidTek can not only do this, but provide you with Contamination Control Audit reports showing the fuel we treat is up to World-Wide Fuel Charter ISO standards
Low cost & high uptime satellite ‘ship to shore’ communications with any asset monitoring sensor your ship needs!
Exceptionally low cost but very high uptime satellite communications for asset monitoring solutions & web based monitoring software
Would you like a very wide choice of condition monitoring sensor data sent to you onshore, continuously in ‘real-time’
How about fuel mass flow, oil quality, vibration, fuel contamination levels & exhaust emission data, all shown live?
This complete asset monitoring system can also be provided on an OPEX basis with single monthly fees, over a period that suits you
