Particle Pal FS9V2-RH
Whether on site or in the laboratory, the Portable Particle Pal FS9V2-RH will provide instant cleanliness readings in ISO, SAE, NAS to allow you to fully understand the condition of your lubricants. The system provides readings in ISO:4406 for up to 4, 6, 14 & 21 micron levels for instant comparison to international or national lubricant cleanliness standards. This system also includes a relative humidity (RH%) function providing a clear insight into the level of water in the fuels being tested. A self contained system, complete with integral pump & controlled flow rate.
Particle Pal Pro Lab
The new Particle Pal Pro Lab utilises the S120 Digital Imaging counter and works with standard 100mL sample volume.Pull through stepper pump running at 20mL/min or less with almost no aeration due to this configuration. Diesel fuel through to lubricants of 3,000+ cSt. Digital imaging combed with advanced algorithms, sorts particles into the following categories for contamination root cause analysis:
- Fatigue Wear
- Cutting Wear
- Sliding Wear
- Fibres
Particle Pal Pro - FS9V3 OLU
The all new Particle Pal Pro – Picture of Health utilises breakthrough digital imaging technology which provides greater insight into the type of particulate in oil or fuel systems. Air bubble elimination & shape recognition gives root cause particle analysis. Remaining oil life & water content sensors complete the package. These units can test lubricants up to 2,400 cSt & also can be fitted with pressure reducing valve to allow on line sampling of up to 320 bar. Digital imaging combed with advanced algorithms, sorts particles into the following categories for contamination root cause analysis:
- Fatigue Wear
- Cutting Wear
- Sliding Wear
- Fibres
The system includes a relative humidity (RH%) sensor & also a full spectrum Tan Delta holistic oil condition sensor providing remaining oil life. This unit provides portability with a test capability range that would result in
Midas Ferrous Debris Monitor
Instantly Test Multiple Oil Samples In-Field & in the Workshop.
Routine wear metal analysis of machinery lubricants provides early warning of impending faults. Midas provides an offline & at-line measurements of ferrous wear debris concentrations. This provides the insight needed to determine If equipment is operating normally or If additional analysis is required.
Midas provides repeatable & accurate determination of ferromagnetic material concentration down to single ppm levels. ‘Grease Thief’ compatible.
Sampling – A lubricant sample is placed in a standard 2ml laboratory sample tube. Debris reading is then taken by simply dropping the plastic sample tube into the sensing chamber & reading the updated display.
-
Instantly Test Multiple Oil Samples In-Field & in the Workshop.
The MOT is a complete mobile oil quality test kit built around the Oil Quality Sensor (OQSx). A small sample of any oil type can be instantly tested and its precise quality reported. Ideal for maintenance depots or mobile crews. Proving lubricant quality levels as well as remaining life % levels (see case study below).
Fully Configurable – Any oil type, MOT allows accurate testing of any oil or fuel oil.Instant Results – Instant diagnosis of potential issues with the ability to store trend data.
Fully Certified
The Oil Quality Sensor (OQSx) is fully certified to international standards.
Portable – MOT is fully portable – ideal for the workshop & for field maintenance crews.
